PECULIARITIES OF PROJECTING OF MOULDS IN CASTING BY MELTED MODEL
Abstract
It is determined that at projecting of the inner cage of moulds it is necessary to take into account such parameters as fraction of the main material of the model, content and granulometric composition of its filling components, characteristics of the material of shell mold.
About the Authors
I. G. Sapchenko
Institute of Machinery and Metallurgy of the Far Eastern Branch of the Russian Academy of Sciences
Russian Federation
S. G. Zhilin
Institute of Machinery and Metallurgy of the Far Eastern Branch of the Russian Academy of Sciences
Russian Federation
O. N. Komarov
Institute of Machinery and Metallurgy of the Far Eastern Branch of the Russian Academy of Sciences
Russian Federation
References
1. Sapchenko I.G., Zhilin S.G. Vliyanie poristosti udalyaemykh modelei na ikh svoistva, kachestvo obolochkovykh form i otlivok v lit'e po vyplavlyaemym modelyam // Liteinoe proizvodstvo. 2003. № 4. S. 12-15.
2. Pat. RF 2227769 / I.G. Sapchenko, S.G. Zhilin. Sposob izgotovleniya udalyaemykh modelei. Opubl. 27.04.2004. Byul. № 12.
3. Kiparisov S.S., Libenson G.A. Poroshkovaya metallurgiya: Ucheb. dlya tekhnikumov. 3-e izd., pererab. M.: Metallurgiya, 1991.
4. Izgotovlenie zagotovok i detalei plasticheskim deformirovaniem / V.M. Avdeev, L.B. Aksenov, I.S. Aliev i dr.; Pod red. K.N. Bogoyavlenskogo, V.V. Risa, A.M. Shelesteeva, L.: Politekhnika, 1991.
For citations:
Sapchenko I.G.,
Zhilin S.G.,
Komarov O.N.
PECULIARITIES OF PROJECTING OF MOULDS IN CASTING BY MELTED MODEL. Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY). 2007;(1):93-95.
(In Russ.)
Views:
599
Email this article 