POWER PARAMETERS OF THE PROCESS OF END FORMING OF THICK WALLED TUBES
Abstract
Analysis of forces acting on the rolls in the radial direction made by the analytical method and with use of computer modeling techniques is made. Application of FEM has allowed to calculate distribution of power parameters of the technological process during time. The deviation of the experimental data on the results of analytical calculation is within 3%.
About the Author
V. A. Tamila
Belarusian National Technical University
Belarus
Minsk, 65, Nezavisimosti ave.
Belarus
Minsk, 65, Nezavisimosti ave.
References
1. Truby stal’nye besshovnye holodnodeformirovannye. Sortament [State Standard 8734–75. Seamless steel tubes cold deformed. Range]. GOST 8734-75.. Moscow, Standartinform Publ., 2007. 12 p.
2. Shkol’nik L. M. i dr. Polye osi i valy [Hollow axles and shafts]. Moscow, Mashinostroenie Publ., 1968. 183 p.
3. Klubovich V. V., Tomilo V. A. Tehnologii izgotovlenija i obrabotki special’nyh periodicheskih profilej [Technology of production and processing of special periodic profiles]. Minsk, BNTU Publ., 2007. 298 p.
4. Henzel’ A., Shpittel’ T. Raschet jenergosilovyh parametrov v processah obrabotki metallov davleniem: Sprav. izd.[Calculation of power parameters in metal forming processes: Ref. ed.]. Moscow, Metallurgija Publ., 1982. 360 p.
Review
For citations:
Tamila V.A. POWER PARAMETERS OF THE PROCESS OF END FORMING OF THICK WALLED TUBES. Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY). 2016;(4):66-72. (In Russ.)
Views:
2240
Email this article 