SOLVING OF THE PROBLEM OF THE BURDEN COMPOSITION OPTIMIZATION BY MEANS OF LINEAR PROGRAMMING
Abstract
The target setting of foundry charge calculations so as to minimize total cost of cast alloy was discussed. The linear programming methods were used to calculate the weight of charge metals which need to be melted to achieve a required composition of cast alloy. The software is developed for any foundry industry (ferrous, non-ferrous alloys production) where charges have to be assembled to achieve a required composition by weight and to minimize total cost of cast alloys.
About the Authors
I. V. Rafalski
Belarusian National Technical University
Belarus
Belarus
G. V. Dovnar
Belarusian National Technical University
Belarus
Belarus
P. E. Lushchik
Belarusian National Technical University
Belarus
Belarus
References
1. Ашманов С.А. Линейное программирование. М.: Наука, 1981.
2. Васильев Ф.П. Численные методы решения экстремальных задач. Изд. 2-е, перераб. и доп. М.: Наука, 1988.
3. Лущик П.Е., Вельский А.В. Расчет шихты для выплавки алюминиевых сплавов // Сб. материалов VI Республ. СНТК «Новые материалы и технологии их обработки». Мн., 21-22 апреля 2005. С. 39-43.
Review
For citations:
Rafalski I.V., Dovnar G.V., Lushchik P.E. SOLVING OF THE PROBLEM OF THE BURDEN COMPOSITION OPTIMIZATION BY MEANS OF LINEAR PROGRAMMING. Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY). 2006;(2-1):154-157. (In Russ.)
Views:
1718
Email this article 