FORMING A PARTING LAYER OF COATING ON THE SURFACE OF THE MOULD DURING DIE-CASTING
Abstract
The paper presents the results of research on the study of the possibility of accumulation of the lubricating layer coating on the surface of the separation process of foundry equipment with high pressure die casting aluminum alloys.
About the Authors
A. Pivovarchik
Yanka Kupala State University of Grodno
Belarus
Assistant professor of «Mechanical Engineering and maintenance of vehicles»
Belarus
Assistant professor of «Mechanical Engineering and maintenance of vehicles»
A. Mikhaltsov
Belarusian National Technical University
Belarus
Associate Professor, Department «Metallurgy of casting alloys»
Belarus
Associate Professor, Department «Metallurgy of casting alloys»
References
1. Spetsialnye tehnologii lit’ya pod davleniem [Special technologies of de-casting]. S-Peterburg, Professiya Publ., 2009. 408 p.
2. Kashircev L. P. Litejnye mashiny. Lityo v metallicheskie formy [Foundry machines. Casting in metal molds]. Moskow, Mashinostroenie Publ., 2005. pp. 31–38.
3. Michaltsov A. M., Pivovarchik A. A. Erozionnaya stojkost smazok pri izgotovlenii otlivok iz alyuminievyx splavov metodom litya pod davleniem [Erosion resistance of lubricsnts in the manufacture of castings of aluminum alloy molding]. Litue i metallurgiya [Foundry and metallurgy]. 2008. no. 2, pp. 47–51.
Review
For citations:
Pivovarchik A., Mikhaltsov A. FORMING A PARTING LAYER OF COATING ON THE SURFACE OF THE MOULD DURING DIE-CASTING. Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY). 2015;(1):62-64. (In Russ.)
Views:
610
Email this article 