Modeling of influence of cooled and uncooled rolls on temperatures and stresses of the industrial ingot surface in the area of the secondary cooling
Abstract
On the basis of the system “ProNRS-2'' there are carried out the computer calculations of tensile and compressive stresses along the length of the ingot of size 250x300 mm for the group of industrial steels. There is received the information about the stresses in ingots from the steel 40X, 70K, 2C45, 20C45, 20XH3A. There is shown, that the highest level of tensile stresses is observed for the ingot from the steel 40X, and the lowest — for the ingot from the steel 70K.
About the Authors
A. N. Chichko
Belarusian National Technical University
Belarus
Belarus
D. M. Kukuj
Belarusian National Technical University
Belarus
Belarus
N. V. Andrianov
Byelorussian Steel Works
Belarus
Belarus
Ju. V. Jatskevich
Belarusian National Technical University
Belarus
Belarus
O. I. Chichko
Belarusian National Technical University
Belarus
Belarus
References
1. Евтеев Д. П., Колыбалов И. Н. Непрерывное литье стали. М.: Металлургия, 1984.
2. ЧичкоА. Н. Компьютерные системы моделирова¬ния физических процессов // Вестник БНТУ. 2003. № 2. С. 42-48.
3. Чичко А. Н., Кукуй Д. М., Соболев В. Ф. идр. Компьютерная система «ПроНРС» и трехмерное моделирование распределения температур, напряжений и углерода в процессе непрерывной разливки стали // Литье и металлургия. 2002. №3. С. 21-27.
4. Колосков М. М. Марочник сталей и сплавов. М.: Машиностроение, 2001.
5. Журавлев В. И., Николаева О. И. Машиностроительные стали. М.: Машиностроение, 1968.
Review
For citations:
Chichko A.N., Kukuj D.M., Andrianov N.V., Jatskevich J.V., Chichko O.I. Modeling of influence of cooled and uncooled rolls on temperatures and stresses of the industrial ingot surface in the area of the secondary cooling. Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY). 2003;(3):131-138. (In Russ.)
Views:
260
Email this article 