Rolling work and power in high-speed finishing blocks of wire mills
Abstract
It is shown that with real drawing-down coefficients used in stand finishing blocks at hot rolling of steel wire rod the rolling speeds when metal can break in strand exit plane are impossible to reach in practice. At rolling of nonferrous wire rod in existing blocks of finishing stands it is necessary to take into account influence of dynamic effect in the deformation centre and to define maximum rolling speed securing solidness of metal at its exit from stands.
About the Authors
V. V. Fillippov
Byelorussian Steel Works
Belarus
Belarus
A. A. Gorbanev
Iron and Steel Institute of NAS Ukraine
Ukraine
Ukraine
S. M. Zhuchkov
Iron and Steel Institute of NAS Ukraine
Ukraine
Ukraine
V. A. Tischenko
Byelorussian Steel Works
Belarus
Belarus
A. B. Steblov
Byelorussian Steel Works
Belarus
Belarus
References
1. Schweanzfeier W. Möglichkeiten und Grenzen neuzeitlicher Walzwerkstechnik // Archiv für das Eisenhüttenwesen. 1971. N10. S. 707-712.
2. Бровман М.Я. Применение теории пластичности в прокатке. М.: Металлургия, 1966.
3. Капланов В. И. Теория высокоскоростной тонколисто¬вой холодной прокатки металлов: Учеб, пособие. Киев: УМК ВО, 1991.
4. Вinkęvieh Е. V., Gorbanev А. А., Mamuzic l.et al Inertial forces at deformation site by rolling in modem high-speed finishing mill stands // Zagreb.: Metalurgija. 1997. Vol. 36. Bd. 235—238.
5. Полухин П. И., Гун Г.Я., Галкин А.М. Сопротивление пластической деформации металлов и сплавов. М.: Металлургия, 1967.
Review
For citations:
Fillippov V.V., Gorbanev A.A., Zhuchkov S.M., Tischenko V.A., Steblov A.B. Rolling work and power in high-speed finishing blocks of wire mills. Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY). 2001;(4):110-112. (In Russ.)
Views:
205
Email this article 