Analytical control in metallurgical production
Abstract
The capabilities of the atomic-emission analysis in the foundry industry are shown when the composition of the starting raw material and final production are controlled. Both the operation principle and basic characteristics of a new atomic-emission spectrometer "EMAS-200", with a linear photodiode emission detector employed in its spectra recording system, are described. Also the applicability of this \^evice for production quality control in metallurgy is shown.
About the Authors
M. N. Kovalenko
Belarussian State University
Belarus
Belarus
V. A. Chekan
Research institute of powder metallurgy
Belarus
Belarus
L. V. Markova
Research institute of powder metallurgy
Belarus
Belarus
V. V. Kolęda
Research institute of powder metallurgy
Belarus
Belarus
A. F. Turutin
Research institute of powder metallurgy
Belarus
Belarus
References
1. Заксас Б. И., Корякин А. Б., Лабусов В. А. и др.// Завод, лаб. 1994. Т. 60. № 9. С. 20—22.
2. Бойков В.Н., Бычков В.М.,3алесский И.Е. и др.// Метрология и приборостроение. 1999. № 1. С. 18—21.Я н т ш П. // Заюд. лаб. 2000. Т. 66. №. 6. С. 67—70.
3. Коваленко М.Н., Зажогин А. П.,Ч екан В.А. и др. // Завод. лаб. 1999. Т. 65. № 4. С. 24—26.
4. Коваленко М.Н., Чекан В. А., Маркова Л. В. и др. // Завод. лаб. 2000. Т. 66. № 1. С. 22-24.
5. Маркова Л. В., Коледа В. В., Турутин А. Ф. // Порошковая металлургия. 1999. Вып. 22. С. 148—151.
6. ГОСТ 9716.1-3-79.
7. ГОСТ 1652.1-77.
8. ГОСТ 8.207-76.
Review
For citations:
Kovalenko M.N., Chekan V.A., Markova L.V., Kolęda V.V., Turutin A.F. Analytical control in metallurgical production. Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY). 2001;(4):127-130. (In Russ.)
Views:
1599
Email this article 