INVESTIGATION OF CHEMICAL COMPOSITION AND MECHANICAL PROPERTIES CHIPPERS BLADES OVERSEAS PRODUCTION
https://doi.org/10.21122/1683-6065-2015-1-105-112
Abstract
The paper presents the results of researches of steels used for the manufacture of imported chipper knives. Recommendations on the choice of steel grades from the CIS countries, similar on the properties of the imported knives. For the manufacture of pilot batches of blades for cutting wood chips were selected steels 5ХНВС, 6ХВ2С, intended for testing of the woodworking enterprises of the Republic of Belarus.
About the Authors
A. Alifanov
Baranovichi State University, Baranovichi
Belarus
Belarus
Alifanov Aleksandr, Doctor of Engineering, Professor, Baranovichi State University, Baranivichi city, 21 Voikova str. Email:alifanov_aav@mail.ru
V. Tsuran
Baranovichi State University, Baranovichi
Belarus
Belarus
Tsuran Vladimir, Ph. D. Candidate, Baranivichi State University, Baranivichi city, 21 Voikova str. Email: curan85@mail.ru.
A. Miljukova
Physical and Technical Institute of the National Academy of Sciences of Belarus
Belarus
Belarus
Milukova Anna, PhD in Engineering, Physicsal and Technical Institute of the Nacional Academy of Sciences of Belarus, Minsk, 10 Kuprevicha str.
References
1. Marochnik stalej i splavov. V. G. Sorokin, A. V. Volosnikova, S. A. Vjatkin i dr. Moscow. Mashinostroenie Publ., 1989, 640 p.
Review
For citations:
Alifanov A., Tsuran V., Miljukova A. INVESTIGATION OF CHEMICAL COMPOSITION AND MECHANICAL PROPERTIES CHIPPERS BLADES OVERSEAS PRODUCTION. Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY). 2015;(1):105-112. (In Russ.) https://doi.org/10.21122/1683-6065-2015-1-105-112
Views:
666
Email this article 