Special aspects of the measurement of the internal geometric parameters of the channel parts of small size
https://doi.org/10.21122/1683-6065-2019-3-107-111
Abstract
Technical measurements of linear-angular sizes of parts and products are the most common in mechanical engineering and make up to 95% of the measurements of all controlled sizes. Measuring control is an integral part of each operation of technological processes of production, assembly, testing of products. The complex method of measuring the external and internal geometric characteristics of a carbide die, given in the article, allows to measure the geometric parameters of small-size parts and to give a final assessment of the product for compliance with the requirements of the project technical documentation.
About the Authors
S. V. Zakhorevich
БМЗ – управляющая компания холдинга «БМК»
Russian Federation
Russian Federation
I. V. Borisovets
БМЗ – управляющая компания холдинга «БМК»
Russian Federation
Russian Federation
I. P. Lazebnikova
БМЗ – управляющая компания холдинга «БМК»
Russian Federation
Russian Federation
References
1. Gluhov V. I. Teorija izmerenij geometricheskih velichin [Theory of measurement of geometric quantities]. Omsk, Izdatel’stvo OmGTU Publ., 2012, 108 p.
2. Jakushev A. I. Spravochnik kontrolera mashinostroitel’nogo zavoda. Dopuski, posadki, linejnye izmerenija [Directory of the controller of the engineering plant. Tolerances, fit, linear measurements]. 1980.
3. Gipp B. A. Kontrol’nye prisposoblenija [Control devices]. Moscow, Mashgiz Publ., 1960, 340 p.
4. Berkov V. I. Tehnicheskie izmerenija [Technical measurements]. Moscow, Vysshaya shkola Publ., 1983, 144 p.
5. Belkin I. M. Sredstva linejno-uglovyh izmerenij [Means of linear-angular measurements.]. Moscow, Mashinostroenie Publ., 1987, 412 p.
Review
For citations:
Zakhorevich S.V., Borisovets I.V., Lazebnikova I.P. Special aspects of the measurement of the internal geometric parameters of the channel parts of small size. Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY). 2019;(3):107-111. (In Russ.) https://doi.org/10.21122/1683-6065-2019-3-107-111
Views:
1746
Email this article 