FABRICATION OF POROUS POWDER MATERIALS WITH CONTROLLED DIRECTION FILTERING

The technology for obtaining of porous powder materials with frame structure on the basis of spherical particles of titanium powder, using application of technological coatings of Тi (Si+Мо), (Si+С) or (W+С) was developed. Formation of the powder with the coating was conducted in molding die under the pressure below the flow limit (under 200 MPa). Reaction sintering in a vacuum furnace was carried out at the temperature of 900 оС with the exposure within 1 hour, which allowed receiving penetration factor over 39·10–13 m2 with the formation of powder porous materials with isotropic structure and increased properties.

1. Poristye poroshkovye materialy s anizotropnoj strukturoj dlja fil’tracii zhidkostej i gazov [Porous powder materials with anisotropic structure for filtration of fluids and gas]. L. P. Pilinevich [i dr.]; pod red. P. A. Vitjazja. Minsk: Topik. Publ., 2005. 252 p.

2. Modelirovanie i raschet parametrov jelektricheskogo razrjada v planarnom magnetrone [Modeling and parameters calculation for electric discharge in a planar magnetron]. S. G. Klopov [i dr.]. Izvestija RAN. Serija Fizicheskaja, 2006. Vol. 70, no. 8, pp.1204–1209.

3. Kostikov V. I., Varenkov A. N. Sverhvysokotemperaturnye kompozicionnye materialy [Extra-high-temperature composite materials]. Moskov, Intermet Inzhiniring Publ., 2003. 560 p.

4. Kiparisov S. S., Perel’man V. E. Nekotorye voprosy teorii deformacii poroshkovyh kompozicionnyh materialov [A number of questions in a deformation theory of powder composite materials]. Progressivnye tehnologicheskie processy v poroshkovoj metallurgii. Minsk: Vysshaja shkola Publ., 1982, pp. 61–76.

5. Morfologija poverhnosti i struktura pokrytij kak pokazateli ocen-ki rabotosposobnosti kompozicionnyh materialov [Surface morphology and coating structure in the capacity of performance evaluations for working efficiency of composite materials]. V. N. Kovalevskij [i dr.]. Lit’e i metallurgija, 2011. no. 3, pp.128–133.