Technological features of piston casting
https://doi.org/10.21122/1683-6065-2020-4-64-67
Abstract
The results of studies of obtaining complex castings from aluminum alloys using the self-filling method are presented. The influence of a number of technological parameters (pouring time, chill cooling mode, the use of self-filling, etc.) on the quality of the resulting piston castings has been studied. The optimal time for filling the chill mold was determined when casting pistons. It is shown that the chill mold cooling mode has a significant impact on the quality of castings.
Keywords
foundry,
piston,
casting,
self-pouring,
permanent mold,
aluminum alloy,
melt,
solidification,
defective castings
About the Author
M. A. Sadokha
Belarusian National Technical University
Belarus
Belarus
Minsk, Belarus, 65, Nezavisimosti ave. Tel. + 375-29-778-84-65.
References
1. Sadoha M.A. Proizvodstvo otlivok iz aljuminievyh splavov lit’em v kokil’ [Production of castings from aluminum alloys by cokeel casting]. Litejnoe proizvodstvo = Foundry, 2017, no. 1, pp. 18–22.
2. Sadoha M.A. Issledovanie tehnicheskih parametrov kokilej dlja poluchenija otlivok porshnej [Study of technical parameters of chill molds for obtaining piston castings]. Lit’e i metallurgija = Foundry production and metallurgy, 2011, no. 3, pp. 58–60.
3. Sadoha M.A. Opredelenie tehnologicheskih parametrov proizvodstva otlivok porshnej vysokonagruzhennyh dizel’nyh dvigatelej [Determination of technological parameters for the production of piston castings for high-load diesel engines]. Lit’e i metallurgija = Foundry production and metallurgy, 2011, no. 3, pp. 61–64.
4. Neljub I.A., Kushel’ P.A., Rovin S. L. Osobennosti i preimushhestva primenenija sovremennyh plastpolimernyh materialov dlja izgotovlenija model’noj osnastki [Features and advantages of using modern plastic-polymer materials for the manufacture of model equipment]. Lit’e i metallurgija = Foundry production and metallurgy, 2010, no. 4, pp. 36–39.
5. Kalinichenko M. L., Dolgij L. P., Rovin S. L., Kukareko V.A., Kalinichenko V.A. Sovremennye sposoby sozdanija model’nyh komplektov dlja lit’ja [Modern Ways to Create Model Casting Kits]. Lit’e i metallurgija = Foundry production and metallurgy, 2018, no. 3, pp. 125–130.
Review
For citations:
Sadokha M.A. Technological features of piston casting. Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY). 2020;(4):64-67. (In Russ.) https://doi.org/10.21122/1683-6065-2020-4-64-67
Views:
585
Email this article 