Study of structure features and properties of thermodifusion heat resistant coatings on copper
https://doi.org/10.21122/1683-6065-2021-1-124-129
Abstract
The article presents data on the features of the structure and properties of heat-resistant layers obtained by thermal diffusion aluminization and siliconization of copper (grade M1) in powder saturating media. The phase composition of the diffusion layers has been investigated, in particular, it has been established that, as a result of aluminization, a heterogeneous structure of the diffusion layer is formed with the participation of Cu3Al and Cu9Al4 aluminides. The data on heat resistance under test conditions with a total duration of 25 hours and a temperature of 800 °C are given. Tests have shown that the best protective properties are possessed by aluminized diffusion layers, which are characterized by a higher sink rate against high-temperature oxidation and cyclic heating conditions. According to the results of the analysis of the microstructures before and after oxidation, the features of the protective action and destruction of the aluminized and silicified diffusion layers were noted. On aluminized specimens, during heat resistance tests, the layer thickness grows deep into the specimen and the aluminum concentration gradually redistributes. For siliconized diffusion layers, a loss of continuity of the protective layer by peeling off sections (swelling) and the appearance of focal of layer corrosion with a test duration of more than 15 h were noted.
About the Authors
V. M. Konstantinov
Belarusian National Technical University
Belarus
Minsk, Belarus, 65, Nezavisimosti ave.
Belarus
Minsk, Belarus, 65, Nezavisimosti ave.
V. G. Dashkevich
Belarusian National Technical University
Belarus
Belarus
I. V. Pletenev
Belarusian National Technical University
Belarus
Minsk, Belarus, 65, Nezavisimosti ave.
Belarus
Minsk, Belarus, 65, Nezavisimosti ave.
References
1. Pakhomov V. S. Korroziya metallov i splavov: Spravochnik [Corrosion of metals and alloys: Handbook]: In 2 books. Book 2. Moscow, Nauka i tekhnologii Publ., 2013, 554 p.
2. Akimov V.A., Radyuk A. G., Titlyanov A. E. Issledovanie vliyaniya oksida alyuminiya na sostav i svojstva mednoalyuminievogo diffuzionnogo sloya [Study of the influence of aluminum oxide on the composition and properties of a copper-aluminum diffusion layer]. Tekhnologiya metallov=Metal Technology, 2010, no. 7, pp. 42–46.
3. Minkevich A. N. Himiko-termicheskaya obrabotka metallov i splavov [Chemical heat treatment of metals and alloys]. Moscow, Mashinostroenie Publ., 1965, 491 p.
4. Kolomytsev P. T. Zharostojkie diffuzionnye pokrytiya [Heat-resistant diffusion coatings]. Moscow, Metallurgiya Publ., 1979, 272 p.
5. Ukraintsev A. E. Razrabotka sostavov i sozdanie na medi diffuzionnyh sloev elektrodugovoj metallizaciej s posleduyushchej termoobrabotkoj. Avtoref. Diss. kand. techn. nauk [Development of compositions and creation of diffusion layers on copper by electric arc metallization with subsequent heat treatment. Abstract of Ph. D. dissertation tech. nauk]. Moscow, 2010, 22 p.
6. Gordeeva L. T., Vavilovskaya N. G., Grigoryan G. V. Okislenie medi pri vysokih temperaturah i povyshenie ee zharostojkosti alitirovaniem [Oxidation of copper at high temperatures and increasing its heat resistance by aluminizing]. Zashchitnye pokrytiya na metallah = Protective coatings on metals, 1968, no. 1, pp. 111–113.
7. Plascencia G., Utigard T., Marín T. The oxidation resistance of copper-aluminum alloys at temperatures up to 1,000 °C. Journal of The Minerals, Metals and Materials Society (JOM). Springer, 2005, vol. 57, pp. 80–84.
8. Radyuk A. G., Titlyanov A. E., Kuznetsov V. E., Ukraintsev A. E. Issledovanie sposobov povysheniya zharostojkosti medi i uluchsheniya svojstv medno-alyuminievogo diffuzionnogo sloya [Study of the methods of increase of copper heat resistance and improvement of properties of copper aluminum diffusion laye]. Cvetnye metally = Non-ferrous metals, 2009, no. 6, pp. 112–113.
9. Diagrammy sostoyaniya dvojnyh metallicheskih system. Tom 1 [State diagrams of binary metal systems. Vol. 1]. Moscow, Mashinostroenie Publ., 1996, 992 p.
Review
For citations:
Konstantinov V.M., Dashkevich V.G., Pletenev I.V. Study of structure features and properties of thermodifusion heat resistant coatings on copper. Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY). 2021;(1):124-129. (In Russ.) https://doi.org/10.21122/1683-6065-2021-1-124-129
Views:
1575
Email this article 