Analysis of properties of casting rods manufactured by the furan process by additive technologies and traditional method
https://doi.org/10.21122/1683-6065-2025-3-29-35
Abstract
Examples of the implementation of additive technologies in the current foundry production are considered. Using the example of the furan process, it is shown that additive technologies in their content can differ significantly from traditional technol gies. Casting cores obtained by the Binder Jet technology differ from cores obtained by the traditional furan process in their increased strength and gas emission. This must be taken into account when designing gating systems to prevent the occurrence of gas defects in castings.
About the Authors
S. A. Kulikov
Minsk Tractor Works
Belarus
Belarus
Minsk,
29, Dolgobrodskaya str.
Yu. A. Kulikov
"Minsk Motor Plant" Holding Managing Company
Belarus
Belarus
Minsk,
4, Vaupshasova str.
References
1. Tolochko N. K. Additivnye tekhnologii v Belarusi: kak vse nachinalos’ [Additive technologies in Belarus: how it all began]. Vestnik VGTU = VSTU Bulletin, 2022, no. 2, pp. 230–238.
2. Golodnov A. I., Zlygostev S. N., Furman I. E. Tekhnologii i oborudovanie additivnogo proizvodstva: ucheb. posobie [Technologies and equipment for additive manufacturing: textbook]. Ekaterinburg, Izd-vo Ural. un-ta Publ., 2022, 128 p.
3. Kanishchev M. V., Uliev L. M. Vvedenie v additivnye tekhnologii. T. 1. Obzor osnovnyh tekhnologij 3D‑pechati: uchebnik [Introduction to additive technologies. T. 1. Review of the main 3D printing technologies: textbook]. Moscow, MISiS, 2023, 352 p.
4. Kulikov S.A., Rudnitsky F. I., Shumigay V.A. Vliyanie granulometricheskogo sostava formovochnyh peskov na prochnost’ sterzhnej, izgotovlennyh po Cold box amin-processu [Influence of granulometric composition of molding sand on the strength of rods manufactured by the Cold box amin process]. Litejnoe proizvodstvo = Foundry production, 2024, no. 3, pp. 14–16.
Review
For citations:
Kulikov S.A., Kulikov Yu.A. Analysis of properties of casting rods manufactured by the furan process by additive technologies and traditional method. Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY). 2025;(3):29-35. (In Russ.) https://doi.org/10.21122/1683-6065-2025-3-29-35
Views:
22
Email this article 