WAYS TO IMPROVE SEDIMENTATION STABILITY OF RELEASE COATING FOR DIE CASTING OF ALUMI-NUM ALLOYS
Abstract
The paper presents the results of a study on the effect of a method for dispersing the size of the component of the dispersed phase separation coatings used in high pressure die casting aluminum alloys.
About the Authors
A. A. Pivovarchyk
Yanka Kupala State University of Grodno
Belarus
Belarus
Pivovarchyk Aliaksandr, аss. рrofessor Department. of innovative technologies engineering.
Contact: 230021, 22, Ozheshko str., Grodno, Belarus, E-mail: piwchik21@tut.by, tel. +375 29 8766824
A. M. Mikhaltsov
Belarusian National Technical University
Belarus
Belarus
Miсhaltsov Aliaksandr, аss. рrofessor Department «Metallurgy of casting alloys».
Contact: 220013, 24, Kolasa str., Minsk, Belarus, E-mail: michaltsov@tut.by, tel. +375 29 6942443.
References
1. Pivovarchyk A. A., Mikhaltsov A. M. Vlijanie sposobov nanesenija razdelitel’nyh pokrytij na tolshhinu smazochnorazdelitel’nogo sloja pri LPD Al-splavov [Influence of methods of applying coatings dividing the thickness of the lubricant layer separation at ATD Al-alloys]. Litejnoe proizvodstvo – Foundry Engineering, 2014, no. 5, pp. 24–25.
2. Krugljakov P. M., Haskova T. N. Fizicheskaja i kolloidnaja himija [Physical and Colloid Chemistry]: uchebnoe posobie dlja studentov, obuchajushhihsja po stroitel’nym special’nostjam. Moscow, Vysshaja shkola Publ., 2010. 317 p.
Review
For citations:
Pivovarchyk A.A., Mikhaltsov A.M. WAYS TO IMPROVE SEDIMENTATION STABILITY OF RELEASE COATING FOR DIE CASTING OF ALUMI-NUM ALLOYS. Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY). 2015;(2):29-32. (In Russ.)
Views:
633
Email this article 