TECHNOLOGICAL EQUIPMENT FOR PLASTIC FORMING OF A WIDE FLANGE IN PIPE BLANK
Abstract
Describes the features of the design of technological equipment for plastic forming wide flanges in pipe blanks and accessories for the implementation of the technological process. Shows the dependence for determining deforming efforts. Scheme of the stamp to simulate the process of flanging and local deformation of the toroidal section in the flange are presented.
About the Authors
L. A. Isaevich
Belarusian National Technical University
Belarus
Isaevich Leonid, Doctor of Technical Sciences, Professor
Belarus
Isaevich Leonid, Doctor of Technical Sciences, Professor
D. M. Ivanickij
Belarusian National Technical University
Belarus
Belarus
Ivanickij Denis, Candidate of Technical Sciences.
65, Nezavisimosti ave., Minsk, 220013 Belarus. Tel. +375 (17) 296-67-76, +375 (29) 708-28-41. E-mail: Denisrodman@tut.by
A. M. Sidorenko
Belarusian National Technical University
Belarus
Belarus
References
1. Romanovskij V. P. Spravochnik po holodnoj shtampovke [Guide of cold stamping]. Leningrad, Mashinostroenie Publ., 1979. 520 p.
2. Gurinovich V. A., Isaevich L. A., Sidorenko M. I., Gurinovich V. A., S h i m a n s k i j A. V. Sposob formoobrazovanija flanca v trubnoj zagotovke [Method of forming a flange in the tube blank]. Patent RB, no. 11069, 2007.
3. Isaevich L. A., Sidorenko M. I., Gurinovich V. A., Shimanskij A. V. Raschet usilija deformirovanija pri plasticheskom formoizmenenii otbortovannogo flanca v trubnoj zagotovke [Calculation of effort of deformation during plastic forming the beaded flange in the pipe blank]. Vestnik BNTU – Bulletin BNTU. 2007, no. 3, pp. 10–15.
Review
For citations:
Isaevich L.A., Ivanickij D.M., Sidorenko A.M. TECHNOLOGICAL EQUIPMENT FOR PLASTIC FORMING OF A WIDE FLANGE IN PIPE BLANK. Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY). 2015;(3):93-96. (In Russ.)
Views:
468
Email this article 