THE INFLUENCE OF THE INGOT MOLD COOLING ON THE STRUCTURE OF SILUMINA CASTINGS AK15M3 AT VERTICAL CENTRIFUGAL CASTING
Abstract
Influence of ways of the mold cooling on structure of castings with diameter of 135 mm from AK15M3 silumin at vertical centrifugal casting is investigated. It is established that for production of castings with diameter 135 mm from AK15M3 silumin with high mechanical and tribotechnical properties it is necessary to apply a shaped mould with water-spray cooling at expense of cooler of 0,42 m3/h.
About the Authors
V. Yu. Stecenko
Institute of Technology of Metals of the NAS of Belarus
Belarus
Belarus
K. N. Baranov
Institute of Technology of Metals of the NAS of Belarus
Belarus
Belarus
R. V. Konovalov
Institute of Technology of Metals of the NAS of Belarus
Belarus
Belarus
References
1. Марукович Е. И., Стеценко В. Ю. Модифицирование сплавов. Минск: Беларуская навука, 2009.
2. Стеценко В. Ю. Ривкин А. И. Новый антифрикционный силумин АК15М3 // Литье и металлургия. 2009. № 3. С. 114–115.
Review
For citations:
Stecenko V.Yu., Baranov K.N., Konovalov R.V. THE INFLUENCE OF THE INGOT MOLD COOLING ON THE STRUCTURE OF SILUMINA CASTINGS AK15M3 AT VERTICAL CENTRIFUGAL CASTING. Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY). 2013;(3):118-120. (In Russ.)
Views:
500
Email this article 