DETERMINATION OF THE OPTIMAL SPEED OF THE MANDREL IN THE CONTINUOUS REELING MILL USING NUMERICAL SIMULATION
https://doi.org/10.21122/1683-6065-2017-1-86-92
Abstract
A proper numerical model of expanding process on a three roll continuous reeling mill was created and number of numerical experiments of the process of tubes rolling were performed. Based on the analysis of the stress-strain state of a rough tubes deformation zone, optimal speed rates of the mandrel providing the decrease in mill rolls and deterioration of mandrel which direct influences on the quality of rough tubes were determined.
About the Authors
Yu. L. Bobarikin
Pavel Sukhoi State Technical University of Gomel
Belarus
Gomel city, 48, Oktyabrya ave
Belarus
Gomel city, 48, Oktyabrya ave
Ya. I. Radkin
Pavel Sukhoi State Technical University of Gomel
Belarus
Gomel city, 48, Oktyabrya ave
Belarus
Gomel city, 48, Oktyabrya ave
References
1. Danchenko V. N., Kolikov A. P., Romantsev B. A., Samusev S. V. Technologia trubnogo proizvodstva [Technologu of tube making]. Moscow, Intermet inzhiniring Publ., 2002. 638 p.
2. Bobarikin Yu. L., Radkin Ya. I. Adekvatnaya chislennaya model’ protsessa raskatki gil’z na trehvalkovom nepreryvnom stane i vybor metoda otsenki isnosa instrumenta [Adequate numerical model of the expanding process on three roll continuous reeling mill and selection of methodology of wear and tear]. Sovremennue metody i technologii sozdaniya i obrabotki materialov [Modern techniques and technologies of production and processing of materials]. V 3 kn. Kn. 3. Obrabotka metallov davleniem [Press forming of metals]. Minsk, FTI NAN Belarusi Publ., 2016. 95 p.
3. Borovik P. V., Usatyak D. A. Novye podhody k matematicheskomy modelirovaniyu technologicheskih protsessov obrabotki davleniem [New approaches to mathematical simulation of press forming proceses]. Alchevsk, DonDTU Publ., 2011. 299 p.
Review
For citations:
Bobarikin Yu.L., Radkin Ya.I. DETERMINATION OF THE OPTIMAL SPEED OF THE MANDREL IN THE CONTINUOUS REELING MILL USING NUMERICAL SIMULATION. Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY). 2017;(1):86-92. (In Russ.) https://doi.org/10.21122/1683-6065-2017-1-86-92
Views:
1977
Email this article 